2020-7-9 · The padding field is a variable length field added to meet IEEE 802.3 specification requirements when small data payloads are used. The DA, SA, type, payload and padding of an Ethernet packet must be no smaller than 60 bytes. Adding the required 4-byte FCS field, packets must be no smaller than 64 bytes.
Ethernet Frame Types – 2000Trainers.com The Ethernet II frame type is by far the most simple. Those extra 2 bytes in the Ethernet header described earlier are used for a Type field in Ethernet II. The Type field simply identifies the upper layer protocol to which data should be passed. For example, a Type field of hex 0800 represents IP, while 8137 means that data is meant for IPX. ethernet - Unknown EtherType - Network Engineering Stack 2020-5-22 The Ethernet II Frame Format - Firewall.cx
通信网原理实验报告Ethernet and ARP_百度文库
The length field in IEEE 802.3 Ethernet frames is always less than hex '05DC'. This corresponds to 1500 bytes which is the maximum frame size for Ethernet. NIC cards look at this field to determine which Ethernet standard is being used. If the field is less than '05DC', it represents a length field, and the frame is an IEEE 802.3 Ethernet frame.
The length field in IEEE 802.3 Ethernet frames is always less than hex '05DC'. This corresponds to 1500 bytes which is the maximum frame size for Ethernet. NIC cards look at this field to determine which Ethernet standard is being used. If the field is less than '05DC', it represents a length field, and the frame is an IEEE 802.3 Ethernet frame.
Jun 04, 2019 · Source MAC Address Field. Source MAC Address, the Media Access Control address of the outgoing network interface card. This 6-byte field identifies the originating device. It must be a unicast address. Ether Type Field. This field size is 2-byte long and it identifies the upper-layer protocol encapsulated in the frame.